OBD2 App that will communicate with yourToyota Engine ECU Vehicles. The Generic OBD2 is also included andwill work with any OBD2 Complaint Vehicle. The app requires OBD2ELM 327 Bluetooth(See Below). It will read Toyota Enhance/ExtendedPIDS (130 PIDS available) and Perform Output Test (70 PIDSavailable). Not all of the PIDS are supported by the vehicle. Itwill support certain ranges of Toyota Models and Years (2000 -2006). It may work on some of the Lexus Models.

ATTENTION: Try Free "DIAG MY TOYOTA" or OBDDiag Toyota with AdsBefore Purchasing this App.

If it works, then you may take advantage with the Pro versionwhich includes Output Test, Nicer GUI, Better Support and morefeatures will be added.

Currently, It will Support ISO-9141 PROTOCOL ONLY for theEnhance Toyota! CAN BUS is Not Supported for the EnhanceToyota!

The Generic OBD2 supports all of the Protocols.

-----------------------------------------------------------
The App Supports the Following (ISO-9141)
-----------------------------------------------------------
* Enhance Data Parameters
* Output Test
* Mode 3 - Read Faults
* Mode 4 - Clear Faults
* Mode 7 - Pending Faults

* Generic Data Parameters (Any OBD2 Complaint Vehicle)
* Readiness
* O2 Sensor Location
* Mode 2 - Freeze Frame Data
* Mode 3 - Read Current Faults
* Mode 4 - Clear Faults
* Mode 6 - On-board Test Result
* Mode 7 - Read Pending Faults
* Mode 9 - VIN, Performance Tracking Data, ECU Name, Calibrationand Verification ID
* Mode A - Read Stored Faults

Output Test parameters is not filtered thoroughly and some of theOutput Test will not work, because the ECU does not support it.

Toyota Enhance Powertrain: Tested successfully on the followingvehicles
* 2004 Toyota Camry
* 2002 Toyota Camry Solara

HARDWARE REQUIREMENT: ELM 327 (Clone Type) Bluetooth Adapter orOBDLink MX
Vendors Type: CHX, OBDII, BAFX Bluetooth Device tested OK.